There are two situations in which the artificial turf presents the problem of curling. One is the curling during construction, and the curling is presented during use. The former is better to solve, because the construction is not finished yet, the latter is more troublesome, because it is now completed, rework in the process of use is very troublesome.
The reason why the artificial turf construction process is relatively simple is because it can be reworked at any time. There are two reasons for the curling at this time. One is that the modified glue is less, the sticking and the sticking are not strong, and the other is the curling edge caused by the too long drying time after applying the glue. This should pay attention to the glue should be moderate, the amount should not be too large, of course, it must not be too small, too much time to dry the sun, together in a very few circumstances will also cause the situation of the edge. After applying the glue, it can be dried for about five to ten minutes, or you can try the sticky strength of the sticky piece. Under normal conditions, when the strength is relatively strong, the time is sticky and it is difficult to pull open, and it can be seen that the glue can be adhered when the glue is pulled. The appearance of this time-coated glue is that there is no active glue, and it is almost dried.
The use of the existing position of the raised edge is the most troublesome, and this repair is quite troublesome. This needs to clean the filled quartz sand and rubber particles, and then clean the dirt under the artificial lawn to make the adhesion. After the adhesion and the contact, the quartz sand and the rubber particles are filled. This is very simple. However, it is very troublesome to go to the construction time, especially the cleaning and filling of quartz sand and rubber particles. It is very difficult to make the connection with the original. Therefore, we must pay more attention to the construction time, take it seriously, and achieve a success.
